Chicago? Grip Hot Latch for Copper Wire

161335H

  • Lighweight, cost-effective grip pulls #8 to #6 AWG bare copper wire
  • Single ”V” groove jaw
  • Max Safe Load of 4500-Pound (2100 kg)
  • Locking loop handles allow the jaws to be held in an open position for easy placement on wire or cable

Chicago Grip热线钳用于铜线

161335H

  • 轻巧,经济的握把将#8转至#6 AWG裸铜线
  • 单”V”凹槽钳口
  • 安全载荷4500磅(2100千克)
  • 锁定环手柄允许钳口保持在打开位置,以便于放置在电线或电缆上

Finding the best grip to pull small copper can be challenging. Copper stretches over time becoming too thin for some grips which may cause slippage. Some smaller grips are harder to manipulate when wearing rubber gloves and are not hot latch compatible. Using a grip that’s too big, too strong or too aggressive could damage the cable. Klein Tools’ 1613 Series Bare Wire Chicago Grip is big enough to work with gloves but small enough to pull #6 and #8 copper without damaging it. It’s just right for the job.

Specifications
Cable Type:
Copper
Cable Diameter:
#8 to #6 AWG
Jaw Type:
Single V
Jaw Length:
4.188” (106.4 mm)
Maximum Safe Load:
4500 lb (2041 kg)
Weight:
2.8 lb (1.3 kg)
UPC:
092644471926
WARNINGS
  • Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
  • When used on/near energized lines, ground, insulate, or isolate grip before pulling.
  • Do not exceed rated capacity.

寻找拉小铜的抓地力可能具有挑战性。随着时间的推移,铜会因某些夹具而变得太薄,这可能会导致滑动。一些较小的握把在戴橡胶手套时难以操纵,并且不兼容热闩。使用太大,太强或太过激进的手柄都可能会损坏电缆。Klein Tools的1613系列裸线芝加哥握把足够大,可以戴上手套但小到足以拉动#6和#8铜而不会损坏它。这项工作恰到好处。

品规格
电缆类型:
电缆直径:
#8到#6 AWG
颚类型:
单V
下颚长度:
4.188”(106.4 mm)
最大安全载荷:
4500磅(2041千克)
重量:
2.8磅(1.3千克)
UPC:
092644471926
警告
  • 每次使用前,清洁钳口区域并检查手柄是否正确操作以避免滑动。
  • 在拉动时在通电线上/附近使用,接地,绝缘或隔离手柄。
  • 不要超过额定容量。