Parallel Jaw Grip 2-1/2-Inch Length
1685-20
- Lightweight, compact grips pull an exceptionally wide range of cable sizes and types
- Designed with a round inside-jaw contour for maximum contact to minimize conductor damage
- Lower jaw is serrated to firmly grip insulated cables and conductors
- Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable
- Large-diameter eye accommodates large hooks on hoists, winches and tackle blocks
平行钳口夹钳2-1 / 2英寸长度
1685-20
- 轻巧紧凑的手柄可以拉伸各种尺寸和类型的电缆
- 采用圆形内颚轮廓设计,可实现接触,从而减小损坏
- 下颚呈锯齿状,牢固地夹住绝缘电缆和导体
- 设计包括一个闩锁,可防止在钳口脱离电缆时手柄掉落
- 大直径眼睛可容纳起重机,绞车和滑车组件上的大钩
Lightweight, compact grips pull an exceptionally wide range of cable sizes and types. Designed with a round inside-jaw contour for maximum contact to minimize conductor damage. Lower jaw is serrated to firmly grip insulated cables and conductors. Design includes a latch that prevents the grip from falling in case of jaw disengagement from the cable.
Specifications
Special Features:
Spring
Cable Type:
Messenger, EHS, Coated
Cable Diameter:
0.157” to 0.875” (3.98 to 22.22 mm)
Jaw Type:
Round – Serrated
Jaw Length:
2.5” (63.5 mm)
Maximum Safe Load:
4500 lb (2041 kg)
Weight:
2.6 lb (1.2 kg)
UPC:
092644471759
WARNINGS
- Before each use, clean jaw area and inspect grip for proper operation to avoid slippage.
- When used on/near energized lines, ground, insulate, or isolate grip before pulling.
- Do not exceed rated capacity.
- Always match proper size and type of grip to application.
- Grips are to be used for temporary installation, not for permanent anchorage.
轻巧紧凑的手柄可以拉伸各种尺寸和类型的电缆。采用圆形内颚轮廓设计,可实现接触,下颚呈锯齿状,牢固地夹住绝缘电缆和导体。设计包括一个闩锁,可防止在钳口脱离电缆时手柄掉落。
产品规格
特殊功能:
弹簧
电缆类型:
信使,EHS,涂层
电缆直径:
0.157”至0.875”(3.98至22.22 mm)
颚类型:
圆形 – 锯齿形
下颚长度:
2.5英寸(63.5毫米)
最大安全载荷:
4500磅(2041千克)
重量:
2.6磅(1.2千克)
UPC:
092644471759
警告
- 每次使用前,清洁钳口区域并检查手柄是否正确操作以避免滑动。
- 在拉动时在通电线上/附近使用,接地,绝缘或隔离手柄。
- 不要超过额定容量。
- 始终将适当尺寸和类型的手柄与应用相匹配。
- 把手用于临时安装,而不是用于永久性锚固。